Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
   2.1. The data on car identification
   2.2. The general data of engines
   2.3. THAT of cars Trooper/Bighorn with the diesel engine
   2.4. Instructions on leaving
      2.4.1. The air filter
      2.4.2. The fuel filter (petrol engines)
      2.4.3. The fuel filter (diesel engines)
      2.4.4. Draining of the water which have collected in fuel system of the diesel engine
      2.4.5. Compulsory system of ventilation картера (PCV-system)
      2.4.6. A tank for catching of steams of gasoline
      2.4.7. Features of check of system of catching of steams
      2.4.8. The storage battery
      2.4.9. Drive belts
      2.4.10. Cooling system
      2.4.11. A central air
      2.4.12. A screen wiper
      2.4.13. Recommended marks of fuel and oil
      2.4.14. Care of a manual transmission or automatic transmission
      2.4.15. Check of level of oil or a liquid
      2.4.16. Oil replacement
      2.4.17. Carter of a distributing box
      2.4.18. A reducer of the back bridge
      2.4.19. A cooling liquid
      2.4.20. The main brake cylinder
      2.4.21. The main cylinder of a hydrodrive of coupling
      2.4.22. A nutritious tank of the hydraulic booster of a wheel
      2.4.23. A reducer of the steering mechanism
      2.4.24. Running gear greasing
      2.4.25. Body greasing
      2.4.26. Greasing of the mechanism of a manual brake
      2.4.27. Greasing of draught of a drive throttle заслонки
      2.4.28. Greasing of the lever of a gear change
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes

Isuzu Trooper>> Maintenance service>> Instructions on leaving>> Cooling system

2.4.10. Cooling system

To check level of a cooling liquid follows monthly. Level should be between labels "Full Cold" and "Full Hot". It is necessary to add a water and antifreeze mix in a proportion 50/50 irrespective of an operation season. Simultaneously with level check it is necessary to check up a condition of hoses. Hoses with wear tracks and damages replace.

The prevention

Every 2 year or 50000 km of run it is necessary to merge a liquid from cooling system, to wash out system and to fill in the fresh liquid recommended by the manufacturer.


1. Turn away a stopper of a mouth of a radiator on the cooled down engine.
2. After the stopper will be removed, start the engine and wait, while in the top hose it will not be felt warmly that specifies in full opening of the thermostat. Translate рычажок managements of a heater in the position corresponding to full opening of an inlet branch pipe of a radiator of a heater.
3. Stop the engine and open drain краник in a ground part of a radiator. Merge a liquid.
4. Wrap a stopper and fill system of cooling with pure water. At desire it is possible to add washing additives.
5. Warm up the engine.
6. Merge water. Repeat procedure until then pure water will not pour down yet.
7. Clear a broad tank for what turn out a tank stopper. Having raised a tank, merge the rests of a liquid and wash out a tank water with soap, then merge and put a tank into place.
8. Close краник and fill in a water and antifreeze mix in a proportion 50/50 to a radiator mouth. Add a liquid in a broad tank to a mark "Full Hot". Close a tank a stopper.
9. Warm up the engine until the top hose of a radiator does not become hot (at an open mouth of a radiator). On the working engine add a water and antifreeze mix in a proportion 50/50 to the basis of a mouth of a radiator. Stop the engine and close a radiator a stopper, having combined an arrow with the union of a hose from a broad tank. Close the heater crane.