Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
   2.1. The data on car identification
   2.2. The general data of engines
   2.3. THAT of cars Trooper/Bighorn with the diesel engine
   2.4. Instructions on leaving
      2.4.1. The air filter
      2.4.2. The fuel filter (petrol engines)
      2.4.3. The fuel filter (diesel engines)
      2.4.4. Draining of the water which have collected in fuel system of the diesel engine
      2.4.5. Compulsory system of ventilation картера (PCV-system)
      2.4.6. A tank for catching of steams of gasoline
      2.4.7. Features of check of system of catching of steams
      2.4.8. The storage battery
      2.4.9. Drive belts
      2.4.10. Cooling system
      2.4.11. A central air
      2.4.12. A screen wiper
      2.4.13. Recommended marks of fuel and oil
      2.4.14. Care of a manual transmission or automatic transmission
      2.4.15. Check of level of oil or a liquid
      2.4.16. Oil replacement
      2.4.17. Carter of a distributing box
      2.4.18. A reducer of the back bridge
      2.4.19. A cooling liquid Check of level of a cooling liquid Replacement of a cooling liquid
      2.4.20. The main brake cylinder
      2.4.21. The main cylinder of a hydrodrive of coupling
      2.4.22. A nutritious tank of the hydraulic booster of a wheel
      2.4.23. A reducer of the steering mechanism
      2.4.24. Running gear greasing
      2.4.25. Body greasing
      2.4.26. Greasing of the mechanism of a manual brake
      2.4.27. Greasing of draught of a drive throttle заслонки
      2.4.28. Greasing of the lever of a gear change
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes

Isuzu Trooper>> Maintenance service>> Instructions on leaving>> Cooling liquid>> Replacement of a cooling liquid Replacement of a cooling liquid

Stopper of a drain aperture

1 – a stopper of a drain aperture
Every 24 month or 50000 km of run it is necessary to merge a liquid from cooling system, to wash out system and to fill in the fresh liquid recommended by the manufacturer. The liquid is replaced on the cold engine.

1. Turn away a stopper of a mouth of a radiator. Start the engine and wait while in the top hose it will not be felt warmly that specifies in full opening of the thermostat.
2. Stop the engine and substitute the pallet under a radiator. Open drain краник in a ground part of a radiator and merge a liquid. If in the block of cylinders drain stoppers of a cooling liquid turn out them are provided.
3. Wrap the crane and fill system of cooling with pure water. Merge water. Repeat procedure until pure water will pour down.
4. Fill in a water and antifreeze mix in a proportion 50/50 to a radiator mouth. Warm up the engine until the top hose of a radiator does not become hot (at an open mouth of a radiator). On the working engine add a water and antifreeze mix in a proportion 50/50 to the necessary level. Close a radiator a stopper.