Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
   2.1. The data on car identification
   2.2. The general data of engines
   2.3. THAT of cars Trooper/Bighorn with the diesel engine
   2.4. Instructions on leaving
      2.4.1. The air filter
      2.4.2. The fuel filter (petrol engines)
      2.4.3. The fuel filter (diesel engines)
      2.4.4. Draining of the water which have collected in fuel system of the diesel engine
      2.4.5. Compulsory system of ventilation картера (PCV-system)
      2.4.6. A tank for catching of steams of gasoline
      2.4.7. Features of check of system of catching of steams
      2.4.8. The storage battery
      2.4.9. Drive belts Check and tension adjustment Definition of a condition of belts with клинообразным section Belts with the goffered stream
      2.4.10. Cooling system
      2.4.11. A central air
      2.4.12. A screen wiper
      2.4.13. Recommended marks of fuel and oil
      2.4.14. Care of a manual transmission or automatic transmission
      2.4.15. Check of level of oil or a liquid
      2.4.16. Oil replacement
      2.4.17. Carter of a distributing box
      2.4.18. A reducer of the back bridge
      2.4.19. A cooling liquid
      2.4.20. The main brake cylinder
      2.4.21. The main cylinder of a hydrodrive of coupling
      2.4.22. A nutritious tank of the hydraulic booster of a wheel
      2.4.23. A reducer of the steering mechanism
      2.4.24. Running gear greasing
      2.4.25. Body greasing
      2.4.26. Greasing of the mechanism of a manual brake
      2.4.27. Greasing of draught of a drive throttle заслонки
      2.4.28. Greasing of the lever of a gear change
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes

Isuzu Trooper>> Maintenance service>> Instructions on leaving>> Drive belts>> Definition of a condition of belts with клинообразным section Definition of a condition of belts with клинообразным section

Cracks on belt section

Are formed at belt clothing on a pulley of too small diameter. Cause an overheat and premature breakage. For small pulleys corrugated belts are used.

Softening (oil hit)

At oil hit occurs отслоение rubbers from a skeleton. The belt makes a fresh start to slip, and then breaks.


Brightness is caused проскальзыванием which is at the bottom of an insufficient charge of the battery, unsatisfactory work of hinged units. At проскальзывании the belt is ground, and in turn проскальзывание amplifies. It is eliminated by tension adjustment.

Otsloenie coverings

After отслоения coverings the skeleton and a belt quickly wears out breaks. At detection of the raised deterioration of a covering check up surfaces of pulleys, presence on them of furrows or roughnesses.


It is last stage of deterioration. At отслоении the skeleton is bared. Before full breakage remains very little.

The prevention

To check a condition of belts of a drive (presence on belts of cracks, stratifications, traces подгорания or mechanical damages) follows through each 25000 km of run.

Define a belt tension on deflection size in the middle between two pulleys, having pressed under moderate effort to a belt a thumb. If distance centre to centre pulleys of 330-400 mm the belt deflection has to be 13 mm, at distance centre to centre pulleys of 178-330 mm the belt deflection should be 6,0 mm. If the deflection differs from norm ослабьте bolts and adjust. Preliminary it is necessary to remove from a belt the eaten soot and dust adjournment, having wiped its rags moistened with solvent.