Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
   3.1. Specifications of the engine and adjusting works
      3.1.1. Spark plugs
      3.1.2. Ignition installation
      3.1.3. Installation of the moment of injection of fuel
      3.1.4. Electronic ignition
      3.1.5. Adjustment of backlashes of valves
      3.1.6. Adjustment of turns of idling on carburettor engines
      3.1.7. Adjustment of turns of idling on engines with injection system
      3.1.8. Adjustment of turns of idling on diesel engines
   3.2. An electric equipment and major repairs of engines
   3.3. The diesel engine of 2,8 litres
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Engines>> Specifications of the engine and adjusting works>> Installation of the moment of injection of fuel

3.1.3. Installation of the moment of injection of fuel
THE GENERAL DATA

DIESEL ENGINES

Labels for installation of the moment of injection of fuel on diesel engine С223


Labels for an establishment коленвала in ВМТ and position of the beginning of injection (according to the tabular data)


Adjustment of position ТНВД

1 – reduction of a corner of the moment of injection

2 – increase in a corner of the moment of injection

PERFORMANCE ORDER
1. Combine risks on the case of the pump and on an assembly plate.
2. Having turned a cranked shaft, will expose the piston of 1st cylinder in position ВМТ of a step of compression. On a pulley-uspokoitele it is provided seven marks, therefore for piston exhibiting in ВМТ it is necessary to find the necessary mark.
3. Remove the top cover of a gear belt, check up a tension of a belt and combination of adjusting labels.
4. Uncover heads of cylinders and get back заглушку, be convinced that the fixing plate freely comes in шлиц at a back end face of a cam-shaft.
5. Disconnect from ТНВД топливопровод a high pressure, turn away the screw of a distributive head, remove a lining and establish the display adaptation. Establish size of lifting of 1,0 mm from плунжера.
6. Turn коленвал on 45-60 back from ВМТ, establish the indicator on a zero.
7. On успокоителе is available seven labels – four labels for installation on the idle engine and three labels for installation on the working engine which are used only industrially.
8. Turn коленвал before combination of a label 12 on успокоителе with the index then consider the indication of the indicator which 0,5 mm should be.
9. If the indication differs from standard, turn коленвал in position, which corresponds to the beginning of the moment of injection (the tab. the Adjusting data for diesel engines see (without the diesel engine of 2,8 litres *)). Turn on two nuts of fastening of a flange of the pump.
10. Establish the pump in such position at which the indicator will show 0,5 mm. Tighten nuts.