Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. An electric equipment and major repairs of engines
      3.2.1. An electric equipment of engines
         3.2.1.1. The ignition coil
            3.2.1.1.1. Check
            3.2.1.1.2. Removal and installation
         3.2.1.2. The ignition block
         3.2.1.3. The induction gauge of ignition for engines V6
         3.2.1.4. The ignition distributor
         3.2.1.5. System of a charge of the battery
         3.2.1.6. System of start-up of the engine
      3.2.2. Major repairs of engines
   3.3. The diesel engine of 2,8 litres
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Engines>> Electric equipment and major repairs of engines>> Electric equipment of engines>> The ignition coil

3.2.1.1. The ignition coil

3.2.1.1.1. Check
THE GENERAL DATA

CARS TROOPER, TROOPER II AND AMIGO/JAZZ C ENGINES 4ZD1 AND 4ZE1

The coil of ignition of cars Trooper, Trooper II and Amigo/Jazz c engines 4ZD1 and 4ZE1

D – a high-voltage conclusion

E – a positive conclusion

C – a negative conclusion

The ohmmeter is necessary for check of primary and secondary windings of the coil of ignition.

PERFORMANCE ORDER
1. Disconnect conducting together with the ignition coil, disconnect a high-voltage wire.
2. Measure resistance between conclusions of windings which should be in following limits:
      – Resistance of a primary winding for engines 4ZD1 (conclusions С–Е) 1,2–1,4 Ohm, for engines ZE1 (conclusions С–Е) – 0,81–0,99 Ohm.
      – Resistance of a secondary winding for engines 4ZD1 (conclusions С–D) 8,6–13,0 clod, for engines 4ZE1 (conclusions С–D) – 7,5–13,5 clod.
      – Resistance of isolation for engines 4ZD1 and 4ZE1 (a conclusion the S-case) not less than 10 Mom.

CARS TROOPER, TROOPER II AND AMIGO C ENGINES V6

The coil of ignition of cars Trooper, Trooper II and Amigo c engines V6

And – to clear


PERFORMANCE ORDER
1. Disconnect from the coil of ignition distributor conducting.
2. Clear a metal arm of the coil.
3. Connect the voltmeter, as is shown in fig. the Coil of ignition of cars Trooper, Trooper II and Amigo c engines V6 (a position 1). Switch an ohmmeter to the top range and measure resistance which should be infinite.
4. Connect an ohmmeter, as is shown in fig. the Coil of ignition of cars Trooper, Trooper II and Amigo c engines V6 (a position 2). Switch an ohmmeter to the bottom range and measure resistance which should be almost equal to zero.
5. Connect an ohmmeter, as is shown in fig. the Coil of ignition of cars Trooper, Trooper II and Amigo c engines V6 (a position 3). Switch an ohmmeter on выскоомный a range and measure resistance which should be big, but not infinite.
6. If the measured resistance differ from specified the ignition coil replace.
7. Attach conducting.