Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. An electric equipment and major repairs of engines
      3.2.1. An electric equipment of engines
         3.2.1.1. The ignition coil
         3.2.1.2. The ignition block
         3.2.1.3. The induction gauge of ignition for engines V6
         3.2.1.4. The ignition distributor
         3.2.1.5. System of a charge of the battery
            3.2.1.5.1. The generator
            3.2.1.5.2. An external regulator of pressure
            3.2.1.5.3. The built in regulator of pressure
         3.2.1.6. System of start-up of the engine
      3.2.2. Major repairs of engines
   3.3. The diesel engine of 2,8 litres
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Engines>> Electric equipment and major repairs of engines>> Electric equipment of engines>> System of a charge of the battery>> The built in regulator of pressure

3.2.1.5.3. The built in regulator of pressure
THE GENERAL DATA

THE BUILT IN REGULATOR OF PRESSURE (EXCEPT ENGINES V6)

Details of the generator with the built in regulator of pressure (except engines V6)

1 – bolts
2 – a nut
3 – a pulley
4 – a rotor in gathering
5 – the screw
6 – a cover of the case of the bearing
7 – the ball bearing
8 – a forward cover
9 – nuts
10 – a back cover
11 – статор in gathering
12 – nuts
13 – a fan plate
14 – plugs of connection of cables from the battery
15 – the condenser
16 – the rectifier
17 – щеткодержатель in gathering with a pressure regulator

Check of the built in regulator of pressure is carried out at the special stand.

Removal and installation

PERFORMANCE ORDER
1. Remove the generator.
2. Turn on and get coupling bolts and separate generator covers.
3. Turn on two nuts of plugs for connection of a cable from the battery (plug VAT), remove щеткодержатель in gathering with the rectifier. Separate статор from a back cover.
4. Remove статор in gathering. Cut off wires in a place of the soldering of diodes and remove статор.
5. Turn away a nut, remove a fan plate, the plug of a cable of the battery, the condenser, the rectifier and a pressure regulator. Drill a rivet of fastening of the diode to щеткодержателю. Отпаяйте conclusion L of the diode from щеткодержателя.

THE BUILT IN REGULATOR PRESSURE (ENGINES V6)

The scheme of connections of the built in regulator of pressure on engines V6