Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. An electric equipment and major repairs of engines
   3.3. The diesel engine of 2,8 litres
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Compression check
      3.3.4. The top dead point of the piston № 1 (ВМТ)
      3.3.5. Backlashes of valves
      3.3.6. A cover of a head of cylinders
      3.3.7. A pulley of a cranked shaft
      3.3.8. Casings of a gear belt of a drive of a camshaft
      3.3.9. A gear belt of a drive of a camshaft
      3.3.10. Asterisks of a gear belt, натяжитель and intermediate pulleys
      3.3.11. Коромысла and pushers
      3.3.12. A head of the block of cylinders
      3.3.13. Oil картер
      3.3.14. The oil pump
      3.3.15. An oil radiator
      3.3.16. Epiploons of a camshaft and a cranked shaft
      3.3.17. A flywheel
      3.3.18. Fastenings of the engine / of a transmission
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes

Isuzu Trooper>> Engines>> The diesel engine of 2,8 litres>> Flywheel

3.3.17. A flywheel


1. Remove a transmission, and then remove coupling.
2. That the flywheel did not rotate, stop it by means of the device similar shown on drawing.
3. Also it is possible to fasten a metal strip to a flywheel and картеру the block of cylinders.
4. Make between a flywheel and cranked shaft of a label on which it will be easier to you to establish a flywheel during assemblage.
5. Turn off fixing bolts and remove them together with a fixing plate, then remove a flywheel. Do not drop it, as it very heavy.


1. Examine a flywheel on presence of deterioration or the chopped off teeth. Replacement of a gear wreath of a flywheel is possible, however it is difficult for executing to the simple motorist; for installation the new gear wreath is necessary for heating up to 200 With.
2. Check up, whether there are no scratches on a surface of a flywheel interfaced to a conducted disk of coupling. If the surface is scratched, the flywheel can be processed on the machine tool, but to replace it more preferably.
3. If you have any doubts concerning a flywheel condition, address to the expert.


1. Clean joined surfaces of a flywheel and a cranked shaft and carefully clear a carving of fixing bolts and a cranked shaft.
2. Establish a flywheel on adjusting pins, then establish a fixing plate and insert bolts. Tighten bolts a hand.
3. Stop a flywheel also as at removal, then gradually tighten all bolts in diagonal sequence till the demanded moment of an inhaling.
4. Establish coupling, then remove the lock tool and establish a transmission.