Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. An electric equipment and major repairs of engines
   3.3. The diesel engine of 2,8 litres
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Compression check
      3.3.4. The top dead point of the piston № 1 (ВМТ)
      3.3.5. Backlashes of valves
      3.3.6. A cover of a head of cylinders
      3.3.7. A pulley of a cranked shaft
      3.3.8. Casings of a gear belt of a drive of a camshaft
      3.3.9. A gear belt of a drive of a camshaft
      3.3.10. Asterisks of a gear belt, натяжитель and intermediate pulleys
      3.3.11. Коромысла and pushers
      3.3.12. A head of the block of cylinders
      3.3.13. Oil картер
      3.3.14. The oil pump
      3.3.15. An oil radiator
      3.3.16. Epiploons of a camshaft and a cranked shaft
      3.3.17. A flywheel
      3.3.18. Fastenings of the engine / of a transmission
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Engines>> The diesel engine of 2,8 litres>> Fastenings of the engine / of a transmission

3.3.18. Fastenings of the engine / of a transmission

Check

PERFORMANCE ORDER
1. If more convenient access to examined parts is required to you, lift a forward part of the car a jack and fix it on support under axes.
2. If necessary unscrew fixing bolts and remove a protective plate of the engine.
3. Examine the rubber shock-absorber of fastening, check up, whether it has burst, whether has hardened and whether was disconnected from fastening. Replace fastening if you find out any damages.
4. Check up, that carving fastenings have been reliably tightened.
5. Using the big screw-driver or mount as the lever and having raised the engine, check up, fastening is worn how much out.
6. If you cannot raise the engine by means of the lever, ask the assistant to move the engine forward and back or here and there while you will examine fastening.
7. If you observe thus excessively free wheeling, check up, whether clips are well tightened, and then replace the worn out details.

Replacement

PERFORMANCE ORDER
The fastenings located with left and on the right side
1. Unscrew bolts, крепящие the fastenings located with left and on the right side, to a body of the car and turn off nuts, крепящие fastenings to engine arms.
2. Lift the engine by means of specially intended lift and get fastenings.
3. To establish fastenings into place, carry out actions on removal of fastenings upside-down.
4. Tighten fixing bolts and nuts till the demanded moment of an inhaling.
Back fastening
5. Turn off nuts, крепящие back fastening to a cross-beam, and then unscrew bolts, крепящие a fixing plate to the bottom party картера transmissions.
6. Establish a jack under a back part of a transmission and lift a jack so that it was possible to remove back fastening.
7. Having established fastening on a desktop, turn off fixing nuts and remove the rubber shock-absorber of fastening from a fixing plate.
8. Installation is spent upside-down removals.
9. At installation reliably twirl all nuts and bolts.