Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
   3.1. Specifications of the engine and adjusting works
   3.2. An electric equipment and major repairs of engines
   3.3. The diesel engine of 2,8 litres
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Compression check
      3.3.4. The top dead point of the piston № 1 (ВМТ)
      3.3.5. Backlashes of valves
      3.3.6. A cover of a head of cylinders
      3.3.7. A pulley of a cranked shaft
      3.3.8. Casings of a gear belt of a drive of a camshaft
      3.3.9. A gear belt of a drive of a camshaft
      3.3.10. Asterisks of a gear belt, натяжитель and intermediate pulleys
      3.3.11. Коромысла and pushers
      3.3.12. A head of the block of cylinders
      3.3.13. Oil картер
      3.3.14. The oil pump
      3.3.15. An oil radiator
      3.3.16. Epiploons of a camshaft and a cranked shaft
      3.3.17. A flywheel
      3.3.18. Fastenings of the engine / of a transmission
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Engines>> The diesel engine of 2,8 litres>> Casings of a gear belt of a drive of a camshaft

3.3.8. Casings of a gear belt of a drive of a camshaft

THE TOP CASING

Removal

PERFORMANCE ORDER
1. Turn off fixing bolts of a protective plate of the engine and remove it.
2. Turn off and remove fixing bolts, then remove the top casing from the engine together with consolidation.
3. Examine consolidation on presence of wear tracks or damages and replace it if it is necessary.

Installation

PERFORMANCE ORDER
1. Installation is spent upside-down removals.
2. Check up, that consolidation has been correctly established.
3. Tighten fixing bolts of a casing till the demanded moment of an inhaling.

BOTTOM (THE BASIC CASING)

Removal

PERFORMANCE ORDER
1. Remove the fan of cooling of a radiator.
2. Remove a pulley of a cranked shaft.
3. Remove the top casing (see above), then turn off bolts of fastening of the bottom casing and remove it from the engine together with consolidation.
4. Examine consolidation on presence of wear tracks or damages and replace it if it is necessary.

Installation

PERFORMANCE ORDER
1. Check up, that consolidation has been correctly established in a casing flute, then put a hermetic strip on the top part of consolidation located under the water pump.
2. Establish the bottom casing on the engine, having checked up, that consolidation has not been shifted, and tighten fixing bolts till the demanded moment of an inhaling.
3. Establish the top casing and consolidation and tighten fixing bolts till the demanded moment of an inhaling.
4. Establish a pulley of a cranked shaft.
5. Establish the fan of cooling of a radiator.