Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
4. System of decrease in toxicity
5. Fuel system
   5.1. Safety measures
   5.2. An order of depressurization of fuel system
   5.3. The mechanical fuel pump
   5.4. The electric fuel pump
   5.5. Removal and installation of the pump mounted in a fuel tank
   5.6. Carburettor adjustment
   5.7. Removal and carburettor installation
   5.8. Systems of injection of fuel
   5.9. The power supply system of diesel engines
      5.9.1. The fuel pump (ТНВД)
      5.9.2. Idling adjustment
      5.9.3. Installation of the moment of injection
      5.9.4. A fuel tank
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Fuel system>> The power supply system of diesel engines>> Installation of the moment of injection

5.9.3. Installation of the moment of injection
THE GENERAL DATA

The index for installation of the moment of injection on engine S223

Installation on labels for engine S223

Installation the injection moments

1 – earlier

2 – later

PERFORMANCE ORDER
1. Check up combination of labels on the case of the pump and on an arm.
2. Establish the piston of 1st cylinder in ВМТ a compression step. For combination it is necessary to use one of seven рисок on a pulley.
3. Remove the top cover of a gear belt, check up a tension of a belt and combination of labels.
4. Uncover heads of cylinders and back заглушку. Check up, whether the control plate comes into a groove at a back end face of a camshaft.
5. Disconnect from the pump a tube, turn away the screw and remove a lining, then establish the adaptation for installation of the moment of the injection, consisting of стрелочного the indicator with a rod. Establish an indicator cam approximately in 1,0 mm from плунжера the pump.
6. Establish the piston of 1st cylinder on 45-60 to ВМТ, expose an indicator scale on a zero.
7. On a pulley is available a little рисок. Four risks are intended for installation of the moment of injection on the idle engine and used at servicing. Three risks are intended for moment installation on the working engine and used for adjustment industrially.
8. Turn a cranked shaft before combination risks 12 with the index. Consider the indication стрелочного the indicator which 0,5 mm should be.
9. If the indication differs from norm establish a cranked shaft in position of the moment of injection. Ослабьте two nuts on a pump flange.
10. Move the pump so that the indicator indication became equal 0,5 mm. Tighten flange nuts.