Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
   6.1. A manual transmission
      6.1.1. The switch of a signal of a backing
      6.1.2. A speedometer reducer
      6.1.3. Removal and manual transmission installation
      6.1.4. 4-step a check point for rear-wheel cars
      6.1.5. 5-step a check point of cars Trooper/Bighorn of early release, 4х4
      6.1.6. 5-step a check point of cars of late release, 4х4
      6.1.7. 5-step a check point "Borg-Warner" cars Rodeo/Passport
      6.1.8. Coupling
         6.1.8.1. A cable of a drive of coupling
         6.1.8.2. Press and conducted coupling disks
         6.1.8.3. The directing bearing
         6.1.8.4. The main cylinder of deenergizing of coupling
         6.1.8.5. The working cylinder of deenergizing of coupling
         6.1.8.6. The dempfirujushchy cylinder
   6.2. Automatic transmission
   6.3. A running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Transmission and running gear>> Manual transmission>> Coupling

6.1.8. Coupling

6.1.8.1. A cable of a drive of coupling
THE GENERAL DATA

Coupling details (details of coupling with a hydraulic drive differ nothing)

1 – a pedal
2 – a spring
3 – a plug of deenergizing of coupling
4 – spring скоба
5 – выжимной the bearing
And – the directing plug
6 – press a disk
7 – a frictional disk
8 – a drive cable

CARS AMIGO/MU/JAZZ RODEO/
PASSPORT AND TROOPER/BIGHORN

On cars of late release the coupling hydrodrive is established. Periodic service of this knot is not required.

Adjustment

PERFORMANCE ORDER
1. Extend a cable cover forward and wrap an adjusting nut until the rubber sealant of a cable will not rest against a partition of a motor compartment.
2. Press three times and release a coupling pedal.
3. Again extend a cable cover forward and tighten an adjusting nut. Release a nut until the backlash (2) does not become equal 5 mm (1 – to a forward part).
4. Release a cover of a cable and tighten a nut.