Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
   6.1. A manual transmission
      6.1.1. The switch of a signal of a backing
      6.1.2. A speedometer reducer
      6.1.3. Removal and manual transmission installation
      6.1.4. 4-step a check point for rear-wheel cars
      6.1.5. 5-step a check point of cars Trooper/Bighorn of early release, 4х4
      6.1.6. 5-step a check point of cars of late release, 4х4
      6.1.7. 5-step a check point "Borg-Warner" cars Rodeo/Passport
      6.1.8. Coupling
         6.1.8.1. A cable of a drive of coupling
         6.1.8.2. Press and conducted coupling disks
         6.1.8.3. The directing bearing
         6.1.8.4. The main cylinder of deenergizing of coupling
         6.1.8.5. The working cylinder of deenergizing of coupling
         6.1.8.6. The dempfirujushchy cylinder
   6.2. Automatic transmission
   6.3. A running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Transmission and running gear>> Manual transmission>> Coupling>> Press and conducted coupling disks

6.1.8.2. Press and conducted coupling disks Removal

PERFORMANCE ORDER
1. Remove a check point (subsection 6.1.3 see).
2. Put labels of mutual orientation of a flywheel and a coupling casing.
3. Establish aligning оправку and turn away coupling bolts, remove coupling.
4. Get spring скобы from a plug of deenergizing of coupling and remove выжимной the bearing together with the directing plug.
5. Remove a plug of deenergizing of coupling.
6. Wash out all details of coupling (behind an exception выжимного the bearing and a frictional disk) in solvent.
7. Check up a condition of details, at detection of signs of strong deterioration of a detail replace.

Installation

At installation of a new frictional disk of coupling it is recommended прошлифовать a reciprocal plane of a flywheel in order to avoid the raised deterioration of frictional overlays.

PERFORMANCE ORDER
1. Before plug installation grease a spherical support of a finger.
2. Establish a plug on a spherical finger.
3. Establish the bearing, having fixed its spring скобами.
4. Centre coupling and combine the labels put at dismantling. Turn and tighten bolts.
5. Establish a check point.