Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
   6.1. A manual transmission
      6.1.1. The switch of a signal of a backing
      6.1.2. A speedometer reducer
      6.1.3. Removal and manual transmission installation
      6.1.4. 4-step a check point for rear-wheel cars
      6.1.5. 5-step a check point of cars Trooper/Bighorn of early release, 4х4
      6.1.6. 5-step a check point of cars of late release, 4х4
      6.1.7. 5-step a check point "Borg-Warner" cars Rodeo/Passport
      6.1.8. Coupling A cable of a drive of coupling Press and conducted coupling disks The directing bearing The main cylinder of deenergizing of coupling The working cylinder of deenergizing of coupling The dempfirujushchy cylinder
   6.2. Automatic transmission
   6.3. A running gear
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes

Isuzu Trooper>> Transmission and running gear>> Manual transmission>> Coupling>> The main cylinder of deenergizing of coupling The main cylinder of deenergizing of coupling

The main cylinder of deenergizing of coupling and pedal adjustment

1 – a pusher

2 – with the cruise-control

3 – without the cruise-control

4 – the switch

5 – an adjusting bolt

6 – a partition of a motor compartment

7 – pedal height

Details of the main cylinder of deenergizing of coupling

1 – the cylinder
2 – the piston
3 – a pusher
4 – a plate
5 – a ring
6 – a cover
7 – a nut
8 – a plug
9 – a lining
10 – a tank
11 – a collar
12 – a float
13 – a lining
14 – a stopper
15 – a cover


1. Disconnect the battery from weight.
2. Working under the car, disconnect a rod of the cylinder from a pedal.
3. Turn away a hydrodrive tube, keeping an adjustable spanner.
4. Turn away bolts and remove the cylinder from a partition of a motor compartment.


1. Establish the cylinder on a partition of a motor compartment, wrap bolts.
2. Wrap a hydrodrive tube.
3. Attach a cylinder rod to a pedal.
4. Remove air from a hydrodrive. For this purpose fill in in a nutritious tank brake liquid DOT 3 and close a tank a stopper. Turn away the union on the working cylinder. Having asked the assistant slowly press a coupling pedal, observe of a liquid following from the union. When the pure liquid will start to follow wrap the union. Turn away the union and ask the assistant to press a pedal to the full and to keep. Wrap the union, release a pedal. During procedure watch liquid level in a tank, without supposing a full devastation. Repeat procedure while in a liquid air vials will not cease to be observed. Having executed the same actions, remove air from демпфирующего the valve (if it is provided).
5. Connect the battery to weight and check up coupling work.


1. Remove the main cylinder (see above).
2. Turn away a nut and remove from a pusher a plug.
3. Get a lock ring, remove a cover and a pusher.
4. Get the piston by means of compressed air.
5. Remove a collar and a nutritious tank.
6. Wash out details in denatured alcohol and dry compressed air.


1. Establish a nutritious tank.
2. Grease the piston and the cylinder with a brake liquid and establish the piston.
3. Establish a pusher, a cover and a ring.
4. Establish on a pusher a plug.
5. Establish the main cylinder (see above).