Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
   6.1. A manual transmission
   6.2. Automatic transmission
   6.3. A running gear
      6.3.1. Forward карданный a shaft, semiaxes and SHRUS
      6.3.2. An internal SHRUS
      6.3.3. Removal and installation forward карданного a shaft
      6.3.4. Dismantling карданных hinges
      6.3.5. Back карданный a shaft
      6.3.6. An average support
      6.3.7. The back bridge
      6.3.8. The forward leading bridge
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Transmission and running gear>> Running gear>> Dismantling карданных hinges

6.3.4. Dismantling карданных hinges
THE GENERAL DATA

Details карданного the hinge

1 – a lock ring
2 – the needle bearing
3 – an epiploon

Formation of bearings крестовины


Dismantling

PERFORMANCE ORDER
1. Lift the car, establish on supports and remove карданный a shaft.
2. If the forward plug кардана acts in film, put labels of mutual orientation to a flange sliding шлицевого connections and on карданный a shaft not to break balancing at assemblage. Get the lock rings fixing glasses of bearings крестовины.
3. For removal крестовины the press, an insert and оправка is required. Diameter of an insert should be slightly less apertures in a plug to push out the bearing, and diameter оправки should provide loss выпрессованного the bearing.
4. Выпрессуйте the bearing on the one hand plugs. If the bearing does not leave completely take its flat-nose pliers.
5. Turn a press and выпрессуйте the opposite bearing.
6. Similarly выпрессуйте other bearings.

Installation

PERFORMANCE ORDER
1. Put in new bearings fresh greasing, insert a bearing glass into a plug кардана, establish крестовину.
The prevention

On a part of cars the butterdish крестовины which should be established before hinge assemblage is provided. After installation check up access possibility to a butterdish.


2. Запрессуйте a bearing glass on 6 mm from plug edge. If at запрессовке the considerable effort is required or крестовина begins заедать in the bearing it means presence the tease in the bearing. In this case крестовину and the bearing follows выпрессовать and to rearrange a bearing glass. Otherwise the bearing will quickly fail.
3. Establish new lock rings.
4. Establish an opposite glass of the bearing and запрессуйте until then while bottom (запрессованный) the bearing will not rest against a lock ring.
5. Establish a new lock ring. If the ring does not enter into a flute, прошлифуйте a ring surface.
6. Establish other bearings крестовины.
7. Check up rotation freedom крестовины in bearings. At jamming besiege thorns of bearings blows of a plastic hammer. If this measure does not give result disassemble карданный the hinge and check up thorns of bearings. It is forbidden to establish a shaft with заедающей крестовиной.