Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
   6.1. A manual transmission
   6.2. Automatic transmission
   6.3. A running gear
      6.3.1. Forward карданный a shaft, semiaxes and SHRUS
      6.3.2. An internal SHRUS
      6.3.3. Removal and installation forward карданного a shaft
      6.3.4. Dismantling карданных hinges
      6.3.5. Back карданный a shaft
      6.3.6. An average support
      6.3.7. The back bridge
      6.3.8. The forward leading bridge
7. A suspension bracket and a steering
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Transmission and running gear>> Running gear>> Back карданный a shaft

6.3.5. Back карданный a shaft
THE GENERAL DATA

Details back карданного a shaft

1 – a bolt of a flange of a reverse gear
2 – a bolt of a flange of forward section карданного a shaft
3 – back section карданного a shaft
4 – a bolt of fastening of an arm of a support of a shaft
5 – forward section карданного a shaft

CARS AMIGO/MU/JAZZ, RODEO/PASSPORT AND TROOPER/BIGHORN

Removal

PERFORMANCE ORDER
Rear-wheel cars
1. Lift the car and establish on supports.
2. Put labels of mutual orientation of a plug and a shaft.
3. Turn away bolts of fastening and remove карданный a shaft.
4. At installation combine the put labels and tighten bolts.
Cars with the wheel formula 4х4
5. Lift the car and establish on supports.
6. Put labels of mutual orientation on a flange карданного a shaft and on a flange of a leading gear wheel of the back bridge.
7. On cars with one карданным shaft turn away a nut of fastening of a flange of a shaft to a flange of a shaft of a leading gear wheel of the back bridge. Lower a shaft and get from transmission.
8. On cars with 2-section карданным shaft execute following procedures:
8.1. Turn away a nut of fastening of a flange of back section of a shaft to a flange of a leading gear wheel of the back bridge.
8.2. Turn away a nut of fastening of a flange of back section of a shaft to a flange of forward section.
8.3. Turn away bolts of fastening of an average support to a body, displace forward section карданного a shaft back and remove from the car.

Installation

PERFORMANCE ORDER
1. On cars with 2-section карданным shaft establish a shaft in a following order:
1.1. Establish forward section карданного a shaft in transmission, establish an average support, turn and tighten bolts of fastening of a support to a body.
1.2. Attach back section of a shaft to a flange of forward section, tighten fastening bolts.
1.3. Attach back section of a shaft to a flange of a shaft of the back bridge, tighten nuts.
2. On cars with 1-section карданным shaft establish a shaft in transmission, connect a flange of a shaft to a flange of a leading gear wheel of the back bridge.