Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
   7.1. A forward suspension bracket
   7.2. Corners of installation of wheels
   7.3. A back suspension bracket
   7.4. A steering
      7.4.1. A steering wheel without a safety pillow
      7.4.2. A steering wheel with a safety pillow
      7.4.3. The switch of the index of turn (the combined switch)
      7.4.4. A key of the switch of ignition and the lock of blocking of a wheel
      7.4.5. The lock of blocking of a wheel
      7.4.6. A steering column
      7.4.7. Steering draughts
      7.4.8. The steering mechanism
      7.4.9. The steering mechanism with the hydraulic booster
      7.4.10. The hydraulic booster pump
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Suspension bracket and steering>> Steering

7.4. A steering

7.4.1. A steering wheel without a safety pillow
THE GENERAL DATA

Details of a steering wheel and steering column

1 – a wheel with 3-mja spokes
2 – a cover
3 – a wheel with 2-mja spokes
4 – the bottom casing of a steering column
5 – the lock case
6 – a steering column
7 – a steering shaft
8 – the top casing of a steering column

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. On a steering wheel with 2-mja spokes turn away screws of a cover of a sound signal and disconnect signal contact.
3. On a steering wheel with three spokes remove молдинг in the wheel centre, having hooked its small screw-driver.
4. On the cars equipped with the panel button of inclusion of a sound signal, remove the button, having hooked it and having disconnected latches.
5. Turn away a nut of a steering wheel and remove a washer. Put on a steering shaft and a wheel of a label of mutual orientation (are specified by arrows) that at assemblage not to break initial position of a wheel.
6. Remove a steering wheel a special stripper.
7. At installation combine the labels put at dismantling, and establish a steering wheel, put on a washer and wrap a nut.
8. Tighten a nut with the moment 35 Н.м.