Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
   7.1. A forward suspension bracket
   7.2. Corners of installation of wheels
   7.3. A back suspension bracket
   7.4. A steering
      7.4.1. A steering wheel without a safety pillow
      7.4.2. A steering wheel with a safety pillow
      7.4.3. The switch of the index of turn (the combined switch)
      7.4.4. A key of the switch of ignition and the lock of blocking of a wheel
      7.4.5. The lock of blocking of a wheel
      7.4.6. A steering column
      7.4.7. Steering draughts
      7.4.8. The steering mechanism
      7.4.9. The steering mechanism with the hydraulic booster
      7.4.10. The hydraulic booster pump
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes

Isuzu Trooper>> Suspension bracket and steering>> Steering>> The hydraulic booster pump

7.4.10. The hydraulic booster pump

Removal and installation

1. Disconnect the battery from weight.
2. Disconnect and muffle hydrodrive tubes on the hydraulic booster pump.
3. Remove from the pump a drive belt.
4. Turn away bolts of fastening of the pump to an arm, remove the pump.
5. Installation is carried out upside-down.
6. Connect the battery to weight and remove air from a hydrodrive (see more low).

Belt adjustment

1. Ослабьте adjusting bolts of the pump.
2. Press a finger on a belt between a roller натяжителя and a pump pulley. The belt deflection should be 10 mm.
3. Adjust a belt tension, turning the pump, tighten bolts.

Removal of air from a hydrodrive

1. On the cold engine fill in a liquid in a nutritious tank to normal level.
2. Warm up the engine to normal working temperature.
3. Stop the engine, check up liquid level in a tank, add to normal level.
4. Start the engine and 3–4 times turn a wheel in both directions against the stop. It is forbidden to keep a wheel in extreme position more than 5 сек, otherwise the liquid will overheat.
5. Expose wheels in driving position on a straight line, stop the engine. If it is necessary to add a liquid make it not less than in 5 minutes.
6. If at a liquid there are vials repeat procedure.