Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
   7.1. A forward suspension bracket
   7.2. Corners of installation of wheels
   7.3. A back suspension bracket
   7.4. A steering
      7.4.1. A steering wheel without a safety pillow
      7.4.2. A steering wheel with a safety pillow
      7.4.3. The switch of the index of turn (the combined switch)
      7.4.4. A key of the switch of ignition and the lock of blocking of a wheel
      7.4.5. The lock of blocking of a wheel
      7.4.6. A steering column
      7.4.7. Steering draughts
      7.4.8. The steering mechanism
      7.4.9. The steering mechanism with the hydraulic booster
      7.4.10. The hydraulic booster pump
8. Brake system
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Suspension bracket and steering>> Steering>> The steering mechanism with the hydraulic booster

7.4.9. The steering mechanism with the hydraulic booster
THE GENERAL DATA

Assembly details of the steering mechanism (a drive with the amplifier)

1 – a draught tip
2 – fastening bolts to the engine
3 – a nut of the rubber buffer of a suspension bracket of an exhaust pipe
4 – a cross-beam of the power unit
5 – a protector
6 – a lock bolt of a steering shaft
7 – an intermediate shaft
8 – tubes of giving of a liquid
9 – the steering mechanism

The design of the steering mechanism for a manual drive is similar.

Removal

PERFORMANCE ORDER
1. Lift the car and establish on supports.
2. Remove a towing plate (if it is provided).
3. Turn away a nut сошки, remove a washer.
4. Put labels of mutual orientation сошки and a shaft.
5. Press сошку from a shaft.
6. Disconnect and muffle hydrodrive tubes on the steering mechanism.
7. Turn out a fastening bolt муфты a steering shaft to the steering mechanism.
8. Turn away bolts of fastening of the steering mechanism to the chassis and remove the steering mechanism.

Installation

PERFORMANCE ORDER
1. Establish the steering mechanism into place and wrap bolts.
2. Wrap a fastening bolt муфты a steering shaft to the steering mechanism, tighten a bolt with the moment 40–49 Н.м.
3. Tighten bolts of fastening of a steering column with the moment 17 Н.м.
4. Establish сошку on a shaft and tighten a nut with the moment 196–236 Н.м.
5. Establish a towing plate (if it is provided).
6. Lower the car.

Adjustment

PERFORMANCE ORDER
1. Establish forward wheels in driving position on a straight line.
2. Release a counternut of the adjusting screw of the steering mechanism.
3. Rotate the adjusting screw clockwise to increase люфт, or counter-clockwise, to reduce.
4. Adjust люфт a steering wheel within 10–30 mm and tighten a counternut with the moment 37–47 Н.м.