Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
   8.1. Adjustment of drum-type brakes
   8.2. A pedal
   8.3. The switch of a signal of braking
   8.4. The main cylinder of brakes
   8.5. The vacuum amplifier of brakes
   8.6. Dosing out valves
   8.7. Hoses of brakes
   8.8. Removal of air from a hydrodrive of brakes
   8.9. Disk brakes
   8.10. A brake support
   8.11. A brake disk
   8.12. Drum-type brakes
   8.13. Antiblocking system of brakes of back wheels
   8.14. Specifications of brakes
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Brake system>> Drum-type brakes

8.12. Drum-type brakes
THE GENERAL DATA

Details of a back drum-type brake

1 – overlays колодок
2 – a hydrodrive tube
3 – bolts
4 – the wheel cylinder

BRAKE DRUMS

Removal and installation

PERFORMANCE ORDER
1. Lift the car and establish on supports.
2. Remove a wheel.
3. Remove a dustproof cover, расшплинтуйте and turn away a nut, remove a washer and get the external bearing.
4. Remove a drum with a nave and the internal bearing.
5. Installation is carried out upside-down. Adjust bearings and replace шплинт.

КОЛОДКИ DRUM-TYPE BRAKES

Removal and installation

PERFORMANCE ORDER
1. Lift the car and establish on supports.
2. Remove a wheel.
3. Remove a drum.
4. Remove pulling together springs колодок.
5. Remove a rack and a lobby spring колодки, remove колодку.
6. Remove распорку and the lever of automatic adjustment колодок.
7. Remove a rack and a spring back колодки.
8. Disconnect a cable of a manual brake from back колодки and remove колодку. Remove with колодки the lever of a manual brake.
9. Before installation колодок slightly grease with high-temperature greasing of a place of their contact with a brake board.
10. Check up a drum condition, presence on it задиров and wear tracks. If necessary pierce a drum. Before расточкой check up diameter of a drum. If the drum is chiseled, get the internal bearing. Before installation carefully wash out a nave.
11. Adjust a backlash between колодками and drums.

THE WHEEL CYLINDER

Removal and installation

PERFORMANCE ORDER
1. Lift the car and establish on supports.
2. Remove a back wheel.
3. Remove a drum and колодки.
4. Disconnect from the wheel cylinder a tube and muffle.
5. Turn away bolts of fastening of the cylinder and remove the cylinder.
6. Installation is carried out upside-down. Remove air from a hydrodrive.