Isuzu Truper - Isuzu Trooper
1. The maintenance instruction
2. Maintenance service
3. Engines
4. System of decrease in toxicity
5. Fuel system
6. Transmission and a running gear
7. A suspension bracket and a steering
8. Brake system
   8.1. Adjustment of drum-type brakes
   8.2. A pedal
   8.3. The switch of a signal of braking
   8.4. The main cylinder of brakes
   8.5. The vacuum amplifier of brakes
   8.6. Dosing out valves
   8.7. Hoses of brakes
   8.8. Removal of air from a hydrodrive of brakes
   8.9. Disk brakes
      8.9.1. Колодки disk brakes
   8.10. A brake support
   8.11. A brake disk
   8.12. Drum-type brakes
   8.13. Antiblocking system of brakes of back wheels
   8.14. Specifications of brakes
9. A body
10. A body electric equipment
11. Diagnostics of malfunctions
12. Electroschemes





Isuzu Trooper>> Brake system>> Disk brakes

8.9. Disk brakes

8.9.1. Колодки disk brakes
THE GENERAL DATA

Details of a forward disk brake

1 – a hose
2 – a bolt
3 – overlays with plates
4 – скоба
5 – a support in gathering
6 – a support arm
7 – a disk and a nave

Details of a back disk brake

1 – a hose, 2 linings, an union bolt
2 – the lever of a manual brake
3 – a bolt
4 – a bolt with a washer
5 – a support in gathering
6 – overlays and скобы
7 – a support arm

On большей parts of cars the deterioration indicator колодок is provided. If at using brakes squeal check up deterioration колодок is distributed. If the indicator plate adjoins to a brake disk, колодки it is necessary to replace (having protected from harmful influence of the dust formed from deterioration of a frictional material).

Removal

Unscrewing of the bottom bolt

Откидывание a support

Removal колодок and plates


PERFORMANCE ORDER
1. Remove from the main cylinder half of volume of a liquid.
2. Lift the car and establish on supports.
3. Remove a wheel.
4. Remove a brake support, without disconnecting a hydrodrive tube. Adhere a support a wire piece, without supposing sagging on a hose.

The prevention

The design of knot of a wheel brake on a part of cars supposes replacement worn out колодок without support removal. To provide access to колодкам turn away the bottom bolt and cast away a support.


5. Remove колодки and plates. Check up a condition of a disk of a brake, if necessary прошлифуйте or replace. Before grinding measure a thickness of a disk and compare with standard (value of a thickness is cast on a disk).

Installation

PERFORMANCE ORDER
1. Drown the piston in the cylinder of a support by means of the special adaptation. On back brakes of cars to drown the piston in the cylinder, it is necessary to turn the piston clockwise against the stop and to combine a rough part of the piston with the support centre.
2. Slightly grease a back part колодок and establish plates. Establish колодки on a support.
3. Establish a support, a wheel and lower the car.
4. Press a pedal some times that колодки have nestled on a disk. Check up liquid level, if necessary add.