Isuzu Trooper>> Body>> Back cover (a cover of a cargo compartment or the hatch)

9.3. A back cover (a cover of a cargo compartment or the hatch)
THE GENERAL DATA

Back cover of car Amigo/MU/Jazz

1 – a latch
2 – a cover лючка
3 – a cover lining лючка
4 – a lining of back lanterns
5 – a cover of wires
6 – a bolt, a nut and a spring washer of the terminator
7 – a bolt of an arm of the terminator
8 – an arm
9 – a loop bolt
10 – a back cover

The top back cover of car Amigo/MU/Jazz

1 – a clamp
2 – the handle
3 – a bolt of a rack of a cover
4 – a rack flange
5 – a rack
6 – шаровый a rack finger
7 – a bolt дефлектора
8 – a sealant дефлектора
9 – a nut дефлектора and the top cover
10 – a flange дефлектора and the top cover
11 – the top back cover
12 – a loop nut from outside bodies
13 – a loop of the top cover
14 – дефлектор
15 – a sealant
And – to a body

The bottom back cover of car Amigo/MU/Jazz

1 – a bolt of a cable of a drive of the bottom cover
2 – a cable of a drive of the bottom cover
3 – a flange of the bottom cover
4 – a loop bolt
5 – the bottom back cover
6 – a loop
7 – торсионный knot
8 – a decorative overlay
9 – details of internal facing
10 – details of internal facing
11 – details of internal facing
12 – protection against water penetration
13 – a water-proof cover
14 – draught of management of the lock
15 – draught of management of the lock
16 – the holder of draught
17 – draught of the cylinder of the lock
18 – the lock of the bottom cover
19 – a fastening bolt актюатора the lock
20 – the handle
21 – a sealant
22 – the cylinder of a drive of the lock
23 – актюатор

Back cover of car Trooper/Bighorn

1 – the top loop

2 – the bottom loop

Removal

PERFORMANCE ORDER

The prevention

Works should be carried out together.


1. Remove the internal panel of a back cover to provide access to wires. Disconnect wires and take aside.
2. Turn away a bolt and a nut of levers of the terminator (if are provided).
3. Remove a washer of levers of the terminator (if are provided).
4. Disconnect a rack of a back cover (if it is provided).
5. Turn away bolts of fastening of loops of a cover (the assistant should keep at this time a cover) and uncover.

Installation

PERFORMANCE ORDER
1. Grease loops, bolts of loops, carving apertures and the terminator консистентной with greasing.
2. Expose a cover and wrap bolts of loops.
3. Tighten bolts, but do not tighten.
4. Slowly cover a cover and adjust its position. A cover not to slam.
5. Open a cover, release bolts and adjust so that backlashes on perimetre were identical, and the cover has appeared заподлицо with a body.
6. After adjustment tighten bolts with the moment 22–30 Н.м.
7. Adjust a lock clamp for what release bolts and displace a clamp easy blows of a plastic hammer. The clamp should settle down in parallel a lock rotor. With a clamp it can be necessary for exact adjustment of gearing of the lock to establish one-two linings.
8. Tighten bolts of a clamp with the moment 12 Н.м.