Isuzu Trooper>> Body>> Salon>> Locks of doors

9.8.2. Locks of doors
THE GENERAL DATA

Car Trooper/Bighorn door-lock

1 – an overlay of the internal handle
2 – a button frame
3 – the lock with the electric drive
4 – the external handle
5 – a larva
6 – the lock
7 – the internal handle
8 – the handle

Larva installation

1 – a door

2 – a larva

3 – скоба

Arrangement of collars on draught of a drive of the internal handle

 

Removal and installation

PERFORMANCE ORDER
1. Remove the door panel (subsection 9.8.1 see), cautiously get a water filter.
2. Disconnect скобы draughts of the door handle.
3. Disconnect and remove draughts of a drive of the lock of a door, having paid attention to their initial installation.
4. Turn on outside screws of fastening of the lock and remove the lock.
5. Get a lock ring and take the cylinder of the lock (larva).
6. Remove the external door handle for what turn on from within two bolts.
7. Remove the internal door handle for what turn away screws of fastening of the handle. On a part of cars of the handle fasten rivets. Drill rivets, having picked up a drill on diameter.
8. If doors are equipped by locks with the electric drive disconnect a socket of wires, turn away screws and remove the lock in gathering.
9. Before installation grease details.
10. Establish details upside-down.
11. Adjust distance L so that backlash L ' at closed position of the lock was absent.
12. Adjust position of draught of a drive of the lock from the internal handle so that the handle was parallel to the door panel.
13. Establish a larva in correct position (at the left – top, on the right – a bottom).
14. If in the mechanism of a drive of the lock draught with adjustable length adjust draught is provided so that in position of lock-out the draught free wheeling was absent.
15. Tighten screws (are specified by arrows) fastenings of the lock and the external door handle with the moment 10 Н.м.