Isuzu Trooper>> Body>> Salon>> Glass and стеклоподъемник

9.8.3. Glass and стеклоподъемник
THE GENERAL DATA

Windshield and regulator стеклоподъемника car Trooper/Bighorn

1 – a trench directing стеклоподъемника
2 – glass
3 – the regulator handle стеклоподъемника
3а – a regulator стеклоподъемника with the electric drive
4 – an external sealant
5 – внутреннмй a sealant
6 – motionless glass in gathering
7 – cover of mobile section

Back glass and regulator стеклоподъемника car Trooper/Bighorn

1 – a trench directing
стеклоподъемника
2 – a sealant
3 – a window leaf
4 – an internal sealant
5 – an external sealant
6 – glass
7 – a regulator стеклоподъемника
7а – a regulator стеклоподъемника with the electric drive
8 – the regulator handle стеклоподъемника
8а – the switch стеклоподъемника

Regulator back and forward стеклоподъемников car Rodeo/Passport

1 – the switch стеклоподъемника
2 – a button frame
3 – the container for dust
4 – an overlay
5 – the decorative panel
6 – an arm
7 – a water filter
8 – glass
9 – a window leaf
10 – a regulator стеклоподъемника with the electric drive
11 – the internal handle
12 – a door-lock with the electric drive
13 – a trench directing стеклоподъемника
14 – the external handle

The prevention

Electric motors стеклоподъемников cars Isuzu are built in the uniform block of a regulator of lateral glass.


Removal and replacement procedures are similar to the same procedures for a manual drive of glasses. Manipulations with the internal door handle are applicable for switches стеклоподъемника.

Removal and installation

PERFORMANCE ORDER
1. Before the beginning of works it is necessary to disconnect wires from a regulator.
Cars Amigo/MU/Jazz
2. Remove the panel of a door and a water filter.
3. Hook and get linear уплотнители glasses.
4. Turn away screws of fastening of the bottom trench to a regulator of a door and having inclined, get glass.
5. Turn away screws of fastening of a regulator and get a regulator through an aperture in a door skeleton.
6. Installation is carried out upside-down.
7. Establish glass and be convinced of correctness of position of the bottom trench.
8. Establish linear уплотнители glasses so that the cut has been turned inside.
Cars Trooper/Bighorn and Rodeo/Passport
9. Remove the panel of a door and a water filter.
10. Hook and get linear уплотнители glasses.
11. Turn away screws of a rotary window leaf and remove a window leaf, having pulled upwards.
12. Turn away screws of the bottom trench and remove door glass.
13. Turn away screws of fastening of a regulator and get a regulator through an aperture in a door skeleton.
14. Installation is carried out upside-down.